Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for IPv6.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Multiple logging servers of both IPv4 and/or IPv6 can be configured.
Related
Commands
logging on — enables the logging asynchronously to logging buffer, console,
Syslog server, and terminal lines.
logging trap — enables logging to the Syslog server based on severity.
logging buffered
Enable logging and specify which messages are logged to an internal buffer. By default, all messages are
logged to the internal buffer.
Syntax
logging buffered [level] [size]
To return to the default values, use the default logging buffered command.
To disable logging stored to an internal buffer, use the no logging buffered
command.
Parameters
level (OPTIONAL) Indicate a value from 0 to 7 or enter one of the
following equivalent words: emergencies, alerts,
critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or
debugging.
size (OPTIONAL) Indicate the size, in bytes, of the logging buffer.
The number of messages buffered depends on the size of
each message. The range is from 40960 to 524288. The
default is 40960 bytes.
1724
Simple Network Management Protocol (SNMP) and Syslog