Filter
Top Products
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
S4820T
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
debug BGP information corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol
operations corresponding to either a default or non-
default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal
format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group
peer-group-
name
Enter the keywords peer-group then the name of the peer
group to debug.
in (OPTIONAL) Enter the keyword in to view only information
on inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information
on outbound BGP routes.
Border Gateway Protocol
433