Filter
Top Products
such as interface range fo 2/0-1,te 10/0,gi 3/0,fa 0/0, this configuration is considered
valid. The comma-separated list is not required to be separated by spaces in between the ranges. You
can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-
address-table static multicast-mac-address vlan vlan-id output-range interface
command.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
This feature is supported on S4820T platform.
Syntax ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command
Modes
CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.
8.3.11.1 Introduced on the Z9000
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was
2094)
8.1.1.0 Introduced on E-Series ExaScale
7.6.1.0 Support added for S-Series
880
Interfaces