Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
port-set
portpipe
number
Enter the keywords port-set then the stack-unit port pipe
number. The range is from 0 or 1.
stack-unit all (OPTIONAL) Enter the keywords stack-unit all to indicate
all stack-unit.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
This feature allows you to determine if the CAM has enough space available before
applying the configuration on an interface.
An input policy map with both Trust and Class-map configuration, the Class-map
rules are ignored and only the Trust rule is programmed in the CAM. In such an
instance, the Estimated CAM output column contains the size of the CAM space
required for the Trust rule and not the Class-map rule.
The following describes the test cam-usage service-policy input
policy-map stack-unit command shown in the following example.
Field Description
stack-unit Indicates the stack-unit slot number.
Portpipe Indicates the portpipe number.
CAM Partition The CAM space where the rules are added.
Available CAM Indicates the free CAM space, in the partition, for the
classification rules.
NOTE: The CAM entries reserved for the default rules
are not included in the Available CAM column; free
entries, from the default rules space, cannot be used as
a policy map for the classification rules.
1498
Quality of Service (QoS)