Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Example
Dell#show management application pkt-fallback-cntr
dns : 0
ftp : 0
ntp : 0
radius : 0
sflow-collector : 0
snmp : 0
ssh : 2
syslog : 0
tacacs : 0
telnet : 0
tftp : 0
Port Channel Commands
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link
according to IEEE 802.3ad. In Dell Networking OS, a LAG is referred to as a Port Channel.
• For the S-Series and Z9000, the maximum port channel ID is 128 and the maximum members per
port channel is 16.
Because each port can be assigned to only one Port Channel, and each Port Channel must have at least
one port, some of those nominally available Port Channels might have no function because they could
have no members if there are not enough ports installed. In the S-Series, stack members can provide
those ports.
NOTE: The Dell Networking OS implementation of LAG or Port Channel requires that you configure
a LAG on both switches manually. For information about Dell Networking OS link aggregation
control protocol (LACP) for dynamic LAGs, refer to the
Link Aggregation Control Protocol (LACP)
chapter. For more information about configuring and using Port Channels, refer to the Dell
Networking OS Configuration Guide.
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
S4820T
Syntax
channel-member interface
860
Interfaces