Filter
Top Products
Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications about entries allowed per ACL, refer to your line card
documentation.
Prior to 7.8.1.0, names are up to 16 characters long.
Example
Dell(conf)#mac-access-list access-list extended TestMATExt
Dell(config-ext-macl)#remark 5 IPv4
Dell(config-ext-macl)#seq 10 permit any any ev2 eq 800 count
bytes
Dell(config-ext-macl)#remark 15 ARP
Dell(config-ext-macl)#seq 20 permit any any ev2 eq 806 count
bytes
Dell(config-ext-macl)#remark 25 IPv6
Dell(config-ext-macl)#seq 30 permit any any ev2 eq 86dd count
bytes
Dell(config-ext-macl)#seq 40 permit any any count bytes
Dell(config-ext-macl)#exit
Dell(conf)#do show mac accounting access-list snickers
interface tengig 1/17 in
Extended mac access-list snickers on TenGigabitEthernet 1/17
seq 10 permit any any ev2 eq 800 count bytes (559851886
packets 191402152148
bytes)
seq 20 permit any any ev2 eq 806 count bytes (74481486 packets
5031686754
bytes)
seq 30 permit any any ev2 eq 86dd count bytes (7751519 packets
797843521 bytes)
Related
Commands
mac access-list standard — configures a standard MAC access list.
show mac accounting access-list — displays MAC access list configurations and
counters (if configured).
permit
To pass packets matching the criteria specified, configure a filter.
Syntax
permit {any | host mac-address | mac-source-address mac-source-
address-mask} {any | host mac-address | mac-destination-address
mac-destination-address-mask} [ethertype operator] [count
[byte]] | [log] [monitor]
To remove this filter, you have two choices:
278
Access Control Lists (ACL)