Filter
Top Products
Version Description
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip pim tib command shown in the following
example.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM
route table.
expires Displays the amount of time until the entry expires and is
removed from the database.
RP Displays the IP address of the RP/source for this entry.
flags List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a
multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and
the entry is ready to switch to SPT
• K = acknowledge pending state
Incoming
interface
Displays the reverse path forwarding (RPF) interface towards
the RP/ source.
RPF neighbor Displays the next hop from this interface towards the RP/
source.
Outgoing
interface list:
Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group
• statically configured member of the Group
• received a (*,G) Join message
Example
Dell#do show ip pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P -
Pruned,
1422
PIM-Sparse Mode (PIM-SM)