Filter
Top Products
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
Usage
Information
The prerequisites for enabling MAB-only authentication on a port are:
• Enable 802.1X authentication globally on the switch and on the port (the dot1x
authentication command).
• Enable MAC authentication bypass on the port (the dot1x mac-auth-bypass
command).
In MAB-only authentication mode, a port authenticates using the host MAC
address even though 802.1xauthentication is enabled. If the MAB-only
authentication fails, the host is placed in the guest VLAN (if configured).
To disable MAB-only authentication on a port, enter the no dot1x auth-type
mab-only
command.
Related
Commands
dot1x mac-auth-bypass — Enable MAC authentication bypass.
dot1x authentication (Configuration)
Enable dot1x globally. Enable dot1x both globally and at the interface level.
Syntax
dot1x authentication
To disable dot1x on a globally, use the no dot1x authentication command.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
802.1X
203