Filter
Top Products
NOTE: For more information, refer to the Flow-based
Monitoring section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Defaults Not configured.
Command
Modes
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When you use the log option, the CP processor logs details about the packets that
match. Depending on how many packets match the log entry and at what rate, the
CP may become busy as it has to log these packets’ details.
NOTE: When you configure the ACL logging and byte counters
simultaneously, byte counters may display an incorrect value. Configure
packet counters with logging instead.
Related
Commands
deny — configures a MAC ACL filter to drop packets.
seq — configure a MAC ACL filter with a specified sequence number.
seq
Configure a filter with a specific sequence number.
Syntax
seq sequence-number {deny | permit} {any | host mac-address |
mac-source-address mac-source-address-mask} {any | host mac-
280
Access Control Lists (ACL)