Filter
Top Products
Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 1/1
Dell(conf-router_rip)#
show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
S4820T
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format
to view RIP information on that network only. If you enter an
IP address, also enter a mask for that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP
address.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Routing Information Protocol (RIP)
1535