Filter
Top Products
Version Description
8.4.2.0 Introduced on the E-Series Tera Scale.
7.7.1.0 Introduced on the E-Series ExaScale.
Related
Commands
ip redirect-list – enables an IP Redirect List.
ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an
interface by entering this command multiple times.
S4820T
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group
name command.
Parameters
redirect-list-
name
Enter the name of a configured redirect list.
Defaults none
Command
Modes
INTERFACE (conf-if-vl-)
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series Tera Scale.
7.7.1.0 Introduced on the E-Series ExaScale.
Usage
Information
You can apply any number of redirect-groups to an interface. A redirect list can
contain any number of configured rules. These rules includes the next-hop IP
address where the incoming traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop.
Otherwise, the normal routing table is used to forward traffic. When a redirect-
group is applied to an interface and the next-hop is reachable, the rules are added
Policy-based Routing (PBR)
1381