Filter
Top Products
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a designated router
or backup designated router.
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.
ip ospf retransmit-interval
Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the
interface.
S4820T
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval
command.
Parameters
seconds Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is 5
seconds.
This interval must be greater than the expected round-trip
time for a packet to travel between two routers.
Defaults 5 seconds
Open Shortest Path First (OSPFv2 and OSPFv3)
1291