Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Legacy E-Series
command.
Usage
Information
When you enter no fefd for an interface and fefd-global, FEFD is enabled on the
interface because the no fefd command is not retained in the configuration file.
To keep the interface FEFD disabled when the global configuration changes, use
the fefd reset command.
Related
Commands
• fefd reset — enables FEFD globally on the system.
• fefd mode — changes FEFD mode on an interface.
fefd interval
Set an interval between control packets.
S4820T
Syntax
fefd interval seconds
To return to the default value, use the no fefd interval command.
Parameters
seconds Enter a number as the time between FEFD control packets.
The range is from 3 to 300 seconds. The default is 15
seconds.
Defaults 15 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1138
Layer 2