Filter
Top Products
Version Description
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Support was added for IPv6 VRRP groups in non-default
VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns
No Active VRRP group.
Syntax
show vrrp ipv6 [vrid] [interface] [brief] [vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP
group to view only that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
view IPv6 VRRP groups corresponding to that VRF.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Virtual Router Redundancy Protocol (VRRP)
1907