Filter
Top Products
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
Use this command to specify the name of the input QoS policy. Once input policy
is specified, rate-police can be defined. This command enables the qos-policy-
input configuration mode— (conf-qos-policy-in).
When changing a Service-Queue configuration in a QoS policy map, all QoS rules
are deleted and re-added automatically to ensure that the order of the rules is
maintained. As a result, the Matched Packets value shown in the show qos
statistics command is reset.
Related
Commands
rate police — incoming traffic policing function.
qos-policy-output
Create a QoS output policy.
S4820T
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name
command.
Parameters
qos-policy-
name
Enter your output QoS policy name in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
1480
Quality of Service (QoS)