Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Defaults Not configured
Command
Modes
CONFIGURATION-STANDARD-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
6.5.10 Expanded to include the optional QoS order priority for the
ACL entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. The
following applies:
The seq sequence-number command is applicable only in an ACL group.
The order option works across ACL groups that are applied on an interface via
the QoS policy framework.
The order option takes precedence over seq sequence-number.
If you do not configure sequence-number, the rules with the same order value
are ordered according to their configuration order.
If you configure sequence-number, the sequence-number is used as a tie
breaker for rules with the same order.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
238
Access Control Lists (ACL)