Filter
Top Products
sum of configured bandwidth allocation to dot1p priority traffic in all ETS priority
groups must be 100%. Allocate at least 1% of the total bandwidth to each priority
group and queue. If bandwidth is assigned to some priority groups but not to
others, the remaining bandwidth (100% minus assigned bandwidth amount) is
equally distributed to nonstrict-priority groups which have no configured
scheduler.
Related
Commands
• qos-policy-output ets — creates a QoS output policy.
• scheduler — schedules priority traffic in port queues.
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port[]
Parameters
port-type Enter the keywords port-type then the slot/port
information.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Data Center Bridging (DCB)
571