Filter
Top Products
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related
Commands
• reload – reboots Dell Networking OS.
• show system (S-Series and Z-Series) – displays the status of all stack members
or a specific member.
stack-unit stack-group
Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure
the unit is assigned to the correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-
id
stack-group stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 15.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Usage
Information
The following message displays to confirm the command.
Setting ports Fo 1/60 as stack group will make their interface
configs obsolete after a reload.[confirm yes/no]: If “y” is
entered, all non-default configurations on any member ports of
1756
Stacking