Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp notifications
Allows you to view information about BGP notifications received from neighbors.
S4820T
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] notifications [in | out]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D
| X:X:X:X::X | peer-group peer-group-name] notifications [in |
out] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to view neighbor BGP notification information
corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group
peer-group-
name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view BGP notifications
received from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP
notifications sent to neighbors
438
Border Gateway Protocol