Filter
Top Products
To enable a disabled neighbor or peer group, use the neighbor {ip-address |
peer-group-name}no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Peers that are enabled within a peer group are disabled when their peer group is
disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP
neighbor or BGP peer group. Use this command with caution as it terminates the
specified BGP sessions. When a neighbor or peer group is shut down, use the show
ip bgp summary
command to confirm its status.
Related
Commands
show ip bgp summary — displays the current BGP configuration.
show ip bgp neighbors — displays the current BGP neighbors.
Border Gateway Protocol
469