Filter
Top Products
qos dscp-color-policy— configures a DSCP color policy
qos dscp-color-map
Configure the DSCP color map.
Syntax
qos dscp-color-map map-name
To remove a color map, use the no qos dscp-color-map map-name command.
Parameters
map-name Enter the name of the DSCP color map. The map name can
have a maximum of 32 characters.
Defaults None
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage
Information
A color map outlines the codepoint mappings to the appropriate color mapping
(green, yellow, red) for the traffic. The system uses this information use to handle
the traffic on the interface based on the traffic priority and places it into the
appropriate shaping queue. You cannot delete a DSCP color map when it is
configured on an interface. If you do, all the DSCP values are set to green (low
drop precedence). To delete the DSCP color map that is being used by one or
more interfaces, remove the DSCP map from each interface.
Example
Dell(conf)#qos dscp-color-map mymap
Related
Commands
qos dscp-color-map— associates the DSCP color map profile with an interface so
that all IP packets received on it is given a color based on that color map
dscp— sets the number of specific DSCP values for color map profile to yellow or
red.
Quality of Service (QoS)
1507