Filter
Top Products
show ip ospf asbr
Display all autonomous system boundary router (ASBR) routers visible to OSPF.
S4820T
Syntax
show ip ospf [process-id | vrf vrf-name] asbr
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
show all ASBR routers visible to the OSPF process that is tied
to a specific VRF.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the process-id option, in support of Multi-Process
OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
To isolate problems with external routes, use this command. In OSPF, external
routes are calculated by adding the LSA cost to the cost of reaching the ASBR
router. If an external route does not have the correct cost, use this command to
determine if the path to the originating router is correct. The display output is not
sorted in any order.
Open Shortest Path First (OSPFv2 and OSPFv3)
1307