Filter
Top Products
ip multicast-routing
Enable IP multicast forwarding.
S4820T
Syntax
ip multicast-routing [vrf vrf-name]
To disable multicast forwarding, use the no ip multicast-routing [vrf
vrf-name] command.
Defaults Disabled.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable IP multicast forwarding on that VRF.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage
Information
After you enable multicast, you can enable IGMP and PIM on an interface. In
INTERFACE mode, enter the ip pim sparse-mode command to enable IGMP
and PIM on the interface.
Related
Commands
ip pim sparse-mode — enables IGMP and PIM on an interface.
Multicast
1217