Filter
Top Products
• hold-interval: 5000 msec
• max-interval: 5000 msec
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
9.0.2.0 Introduced on the S6000..
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage
Information
LSAs are sent after the start-interval and then after hold-interval until the maximum
interval is reached. In throttling, exponential backoff is used when sending same
LSA, so that the interval is multiplied until the maximum time is reached. For
example, if the start-interval 5000 and hold-interval 1000 and max-interval
100,000, the LSA is sent at 5000 msec, then 1000 msec, then 2000 msec, them
4000 until 100,000 msec is reached.
timers throttle lsa arrival
Configure the LSA acceptance intervals.
S4820T
Syntax
timers throttle lsa arrival arrival-time
To return to the default, use the no timers throttle lsa command.
Parameters
arrival-time Set the interval between receiving the same LSA repeatedly,
to allow sufficient time for the system to accept the LSA. The
range is from 0 to 600,000 milliseconds.
Defaults 1000 msec
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Open Shortest Path First (OSPFv2 and OSPFv3)
1343