Filter
Top Products
Usage
Information
First-Hop information is not shown for installed routes in the IPv6 content
addressable memory (CAM). However, the same is shown in the forwarding
information base (FIB).
NOTE: If a route has a mask greater than 64, no output is displayed and no
output is displayed for show ipv6 cam stack-unit unit-number port-
set {0-1} ipv6-address
, but an equivalent /64 entry would be listed in
the show ipv6 cam stack-unit unit-number port-set {0-1}
output. Similarly, if there is more than one ECMP object with a destination
route that has a mask greater than 64, if the first 64 bits in the destination
routes of the ECMP objects are the same, only one route is installed in CAM
even though multiple ECMP path entries exist.
NOTE: The self address is displayed in the neighbor portion for the show
ipv6 cam stack-unit unit-number port-set command.
show ipv6 control-plane icmp
Displays the status of the icmp control-plane setting for the error eate limit setting.
S4820T
Syntax
show ipv6 control-plane icmp
Default 100
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related
Commands
ipv6 flowlabel-zero — Configure IPv6 address auto-configuration for the
management interface.
IPv6 Basics
1003