Filter
Top Products
ntp server
Configure an NTP time-serving host.
Syntax
ntp server[vrf vrf-name] {hostname | ipv4-address | ipv6-
address} [key keyid] [prefer] [version number]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to configure a NTP time-serving host corresponding to
that VRF.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of
NTP server.
hostname Enter the hostname of the server.
key keyid (OPTIONAL) Enter the keyword key and a number as the
NTP peer key. The range is from 1 to 4294967295.
prefer (OPTIONAL) Enter the keyword prefer to indicate that this
peer has priority over other servers.
version number (OPTIONAL) Enter the keyword version and a number to
correspond to the NTP version used on the server. The range
is from 1 to 4.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.6(0.0) Added support for VRF.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added IPv6 support.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
System Time and Date
1795