Filter
Top Products
Parameters
seconds Enter the number of seconds for the maximum response
time. The range is from 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp ssm-map
To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
S4820T
Syntax
ip igmp [vrf vrf-name] ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them
with (*,G) state, use the ip igmp [vrf vrf-name] ssm-map std-access-
list source-address
command.
Internet Group Management Protocol (IGMP)
769