Filter
Top Products
interface loopback
Configure a Loopback interface.
S4820T
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Parameters
number Enter a number as the interface number. The range is from 0
to 16383.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Example
Dell(conf)#interface loopback 1655
Dell(conf-if-lo-1655)#
Related
Commands
interface — configures a physical interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
802
Interfaces