Filter
Top Products
Version Description
6.2.1.1 Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
A system message appears after you enter or delete the virtual-address
command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with the same IP address as the interface’s primary IP address and
change the priority of the VRRP group to 255.
You can ping the virtual addresses configured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
seconds Enter the number of seconds for the delay for VRRP
initialization after an interface becomes operational. The
range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies to a single interface. When used with the vrrp delay
reload
CLI, the later timer rules the VRRP enabling. For example, if vrrp delay
reload is 600 and the vrrp delay minimum is 300:
1902
Virtual Router Redundancy Protocol (VRRP)