Filter
Top Products
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.
ipv6 router ospf
Enable OSPF for IPv6 router configuration.
S4820T
Syntax
ipv6 router ospf process-id [vrf vrf-name]
To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
Enter the process identification number. The range is from 1
to 65535.
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the
VRF to install IPv6 routes in that VRF.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
maximum-paths
Enable the software to forward packets over multiple paths.
S4820T
Syntax
maximum-paths number
1364
Open Shortest Path First (OSPFv2 and OSPFv3)