Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
show ip interface — displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
S4820T
Syntax
ip route [vrf vrf-name] ip-address mask {ip-address | interface
[ip-address]} [distance] [permanent] [tag tag-value] [vrf vrf-
name] [weight weight-value]
To delete a specific static route, use the no ip route destination mask
command.
To delete all routes matching a certain route, use the no ip route
destination mask command.
Parameters
vrf vrf-name (Optoinal) Enter the keyword vrf and then the name of the
VRF to configure a static route corresponding to that VRF.
Use this VRF option after the
ip route keyword to
configure a static route on that particular VRF.
destination Enter the IP address in dotted decimal format of the
destination device.
mask Enter the mask in the slash prefix format (/x) of the
destination IP address.
ip-address Enter the IP address of the forwarding router in dotted
decimal format.
interface Enter one of the following keyword followed by the slot/port
number:
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
926
IPv4 Routing