Filter
Top Products
To remove ACL match criteria from a class map, use the no match ip access-
group access-group-name [set-ip-dscp value | set-color value]
command.
Parameters
access-group-
name
Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the
class-map specifies.
set-ip-dscp
value
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
set-color value (Optional) Enter the keyword set-color followed by a color
value. Traffic that fulfills the match criteria is marked with the
color value that you specify. The default value is Yellow.
Defaults none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria. For class-map match-any, a
maximum of five ACL match criteria are allowed. For class-map match-all,
only one ACL match criteria is allowed.
Related
Commands
class-map — identifies the class map.
Quality of Service (QoS)
1471