Filter
Top Products
Version Description
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Added support for the violate-action and detail
options.
6.5.1.0 Added support for Port Channel.
Example
Dell#show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/1 10 0 0 0
Te 1/2 5 0 0 0
Dell#show mac learning-limit interface tengigabithethernet 1/1
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/1 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and
use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP,
ACLs and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN
interface may continually switch between Master and Backup.
NOTE: For more information, refer to VLAN Stacking and VLAN-related commands, such as
portmode hybrid in the Interfaces chapter.
default vlan-id
Specify a VLAN as the Default VLAN.
S4820T
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the
no default vlan-id vlan-id syntax.
Parameters
vlan-id Enter the VLAN ID number of the VLAN to become the new
Default VLAN. The range is from 1 to 4094. The default is 1.
Defaults The Default VLAN is VLAN 1.
1124
Layer 2