Filter
Top Products
address/mac-address, interface/interface, or vlan
vlan-id.
static (OPTIONAL) Enter the keyword static to display only those
MAC addresses specifically configured on the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
aging-time Enter the keyword aging-time to display only aging-time
information.
interface
interface
(OPTIONAL) Enter the keyword interface then the
interface type, slot/port information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
interface
interface-type
(OPTIONAL) Instead of entering the keyword interface
then the interface type, slot/port information, as above, you
can enter the interface type, then just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1
to 4094.
count (OPTIONAL) Enter the keyword count, then optionally, by an
interface or VLAN ID, to display total or interface-specific
static addresses, dynamic addresses, and MAC addresses in
use.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Updated the output.
1118
Layer 2