Filter
Top Products
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the
virtual-address command and enter no disable.
Related
Commands
virtual-address — specifies the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the
initialization of the VRRP MASTER, the new switch can stabilize its routing tables.
Syntax
hold-time {seconds | centisecs centisecs}
To return to the default value, use the no hold-time command.
Parameters
seconds Enter the number of seconds. The range is from 0 to 65535.
The default is zero (0) seconds.
centisecs
centisecs
Enter the keyword centisecs then the number of centisecs
in units of 25 centisecs . The range is from 0 to 65525 in
units of 25 centisecs.
Defaults zero (0) seconds or or (0) centiseconds
Command
Modes
VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added support for centisecs on the Z9000, S6000, S4820T,
S4810, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
1892
Virtual Router Redundancy Protocol (VRRP)