Filter
Top Products
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage
Information
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable
MSTP globally on the switch, enter the no disable command while in MULTIPLE
SPANNING TREE mode.
For more information about the multiple spanning tree protocol, refer to the Dell
Networking OS Configuration Guide.
Example
Dell(conf)#protocol spanning-tree mstp
Dell(config-mstp)#no disable
Related
Commands
disable — disables multiple spanning tree.
revision
The revision number for the multiple spanning tree configuration.
S4820T
Syntax
revision range
To return to the default values, use the no revision command.
Parameters
range Enter the revision number for the MST configuration. The
range is from 0 to 65535. The default is 0.
Defaults 0
Command
Modes
MULTIPLE SPANNING TREE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1202
Multiple Spanning Tree Protocol (MSTP)