Filter
Top Products
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
You can use the redistribute command to advertise the IGP cost as the MED
on redistributed routes. When you set the route-map with metric-type internal and
apply outbound to an EBGP peer/peer-group, the advertised routes corresponding
to those peer/peer-groups have the IGP cost set as
MED.
When you enter the redistribute isis process-id command without any
other parameters, Dell Networking OS redistributes all OSPF internal routes,
external type 1 routes, and external type 2 routes. RFC does not support this
feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
S4820T
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
Defaults Not enabled.
Command
Modes
CONFIGURATION
480
Border Gateway Protocol