Filter
Top Products
Field Description
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
EC Displays the number of ECMP paths.
If weighted ECMP is enabled, then the show ip fib stack-unit command
display a new column named W-EC (Weighted ECMP). This column displays either
a value of 1 or 0 depending on whether or not a route is assigned with a weight.
Example
Dell#show ip fib stack-unit 1
Destination Gateway First-Hop Mac-
Addr Port VId EC
---------------------------------------------------------------
----------------------------
1.1.1.2/32 via 1.1.1.2, Vl 1000 1.1.1.2
00:01:00:00:00:02 Te 3/42 1000 0
2.1.1.2/32 via 2.1.1.2, Vl 20 2.1.1.2
00:03:00:00:00:02 Po 10 20 0
0.0.0.0/0 - 0.0.0.0
00:00:00:00:00:00 CP 0 0
1.1.1.0/24 Direct, Vl 1000 0.0.0.0
00:00:00:00:00:00 CP 1000 0
1.1.1.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 0
2.1.1.0/24 Direct, Vl 20 0.0.0.0
00:00:00:00:00:00 CP 20 0
2.1.1.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 0
100.1.1.0/24 via 1.1.1.2, Vl 1000 1.1.1.2
00:01:00:00:00:02 Te 3/42 1000 1
100.1.1.0/24 via 2.1.1.2, Vl 20 2.1.1.2
00:03:00:00:00:02 Po 10 20 1
Dell#
Dell#show ip route
S 10.1.1.0/24 via 1.1.1.2, Vl 10
via 2.1.1.2, Vl 20
S 20.1.1.0/24 via 3.1.1.2, Vl 30
S 100.1.1.0/24 via 10.1.1.0, weight 7
via 20.1.1.0, weight 1
Example (Show
command
output with
Weighted
ECMP Enabled)
Dell#show ip fib stack-unit 1
Destination Gateway First-Hop Mac-
Addr Port VId EC RC W
---------------------------------------------------------------
----------------------------------------------
0.0.0.0/0 - 0.0.0.0
00:00:00:00:00:00 CP 0 0 - -
1.1.1.0/24 Direct, Lo 0 0.0.0.0
00:00:00:00:00:00 CP 0 0 - -
1.1.1.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 0 - -
952
IPv4 Routing