Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Parameters
interface Enter one of the following interfaces and slot/port
information:
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
in | out | both Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and
outgoing interfaces.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is from
1 to 4094.
count value Enter the keyword count then the number of debug
outputs. The range is from 1 to 100.
Defaults Debug disabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series, E-Series, and E-Series ExaScale.
7.4.1.0 Introduced
1674
Service Provider Bridging