Filter
Top Products
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
S4820T
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]
To remove a DSCP value as a match criteria, use the no match {ip | ipv6 |
ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.
Parameters
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic.
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
dscp-list Enter the IP DSCP values that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 63.
set-ip-dscp
value
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added the ipv6 and ip-any options on the Z9000, S6000,
S4820T, S4810, MXL.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
1472
Quality of Service (QoS)