Filter
Top Products
net
To configure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If
you did not configure a NET, the IS-IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-
entity-title
Specify the area address and system ID for an IS-IS routing
process. The first 1 to 13 bytes identify the area address. The
next 6 bytes identify the system ID. The last 1 byte is the
selector byte, always identified as zero zero (00). This
argument can be applied to an address or a name.
Defaults Not configured.
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that
interface.
Syntax
passive-interface interface
To delete a passive interface configuration, use the no passive-interface
interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
1072
Intermediate System to Intermediate System (IS-IS)