Filter
Top Products
Parameters
linecard
number
Enter the keyword linecard then the line card slot number.
port-set
number
Enter the keywords port-set then the line card’s port pipe.
The range is from 0 or 1.
all Enter the keyword all to apply to all line cards.
wred-profile
name
(OPTIONAL) Enter the keywords wred-profile then your
WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile
names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
7.4.1.0 and 6.5.3.0 Introduced on the E-Series.
Usage
Information
This command does not uniquely identify a queue, but rather identifies only a set of
queues. The WRED Curve is applied to all eight ingress Multicast queues.
NOTE: The multicast-bandwidth option is not supported on queue
ingress. If you attempt to use the
multicast-bandwidth option, the
following reject error message is generated: % Error:Bandwidth-percent
is not allowed for ingress multicast
.
rate-police
Specify the policing functionality on incoming traffic.
S4820T
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]]
Quality of Service (QoS)
1483