Filter
Top Products
Section 12 Bus State Controller (BSC)
Rev. 4.00 Sep. 14, 2005 Page 285 of 982
REJ09B0023-0400
Bit Bit Name
Initial
Value R/W Description
10
9
BSZ1
BSZ0
1*
1*
R/W
R/W
Data Bus Size
Specify the data bus sizes of spaces.
The data bus sizes of areas 2, 3, 4 and 5A are shown
below.
00: Reserved (setting prohibited)
01: 8-bit size
10: 16-bit size
11: 32-bit size
For MPX-I/O, selects bus width by address
Notes: 1. If area 5B is specified as MPX-I/O, the bus
width can be specified as 8 bits or 16 bits by
the address according to the SZSEL bit in
CS5BWCR by specifying these bits to 11.
2. The data bus width for area 0 is specified by
the external pin. The BSZ1 and BSZ0 bit
settings in the CS0BCR register are
ignored.
3. If area 6 is specified as burst MPX-I/O, the
bus width can be specified as 32 bits only.
4. If area 2 or area 3 is specified as SDRAM
space, the bus width can be specified as
either 16 bits or 32 bits.
8 to 0 All 0 R Reserved
These bits are always read as 0. The write value
should always be 0.
Note: * The CS0CR samples the external pins (MD3) that specify the bus width at power-on
reset.