Filter
Top Products
Chapter 1 Operation Screens
> 1.1 Initial Screen
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
18
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
3 Click the "ETERNUS" logo on the title screen.
The "ETERNUS" indicates "ETERNUS DX410/DX440" or "ETERNUS DX8100/DX8400/
DX8700".
→ The ETERNUS DX400/DX8000 series logon screen appears. See "2.1 Logon" (page
37) for details on how to logon.
End of procedure
• There are two methods to specify the ETERNUS DX400/DX8000
series IP address: using "http" or "https". When placing emphasis
on security, use "https".
• Security certificate errors can occur when using https to access
an ETERNUS DX400/DX8000 series. Refer to "Appendix B Notes
on Access via https" (page 816) for a procedure to solve this https
access error.
• An IP address is not set for the ETERNUS DX400/DX8000 series
USER port at the factory, and should be set using the following
procedure:
1.Have the customer assign an IP address for the USER port.
2.When the ETERNUS DX400/DX8000 series is installed, use a LAN
straight through cable to connect the FST(*1) to the FST port whose
master LED is on.
*1: Maintenance engineer's Field Support Terminal.
3.Set the USER port IP address from the FST using the "Set IP Address for
USER Port" menu. This setting should be performed by the maintenance
engineer.
4.Use the USER port IP address (the ETERNUS DX400/DX8000 series's
IP address) and start the PC.