Filter
Top Products
Appendix A Screen Details
> A.18 Set CA Parameters
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
745
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
• Loop-ID
- Select a Loop-ID (0x00 to 0x7D) for the FC-RA Port from the list box.
The default setting is "0x00".
- Select a Loop-ID setting order (Descending/Ascending) for the FC-RA Port from the list
box.
• Transfer Rate
Select a Transfer Rate for the FC-RA Port from the list box.
- For FC4G
• 4G/2G/1Gbit/s Auto: Selects the transfer rate automatically. (Default)
• 4Gbit/s: Sets the transfer rate to 4Gbit/s.
• 2Gbit/s: Sets the transfer rate to 2Gbit/s.
• 1Gbit/s: Sets the transfer rate to 1Gbit/s.
- For FC8G
• 8G/4G/2Gbit/s Auto: Selects the transfer rate automatically. (Default)
• 8Gbit/s: Sets the transfer rate to 8Gbit/s.
• 4Gbit/s: Sets the transfer rate to 4Gbit/s.
• 2Gbit/s: Sets the transfer rate to 2Gbit/s.
A.18.3 Set CA Parameters (RFCF-RA Detailed Settings) Screen
Set the detailed information of the RFCF-RA Port selected on the [Set CA Parameters (Initial)]
screen. The installation location of the RFCF-RA Port is displayed on the screen as [CM#x CA#y
Port#z].
● Setting item
• Connection Topology
Select the connection topology for the RFCF-RA Port by clicking the radio button.
- Fabric Connection
Communicates between multiple nodes simultaneously by using Fibre Channel
Switch(es). (Default)
• This setting is enabled only when the [FC-AL Connection] and
[Loop-ID (Manual)] is selected for the Connection Topology.
• Do not select the same Loop-ID as any other ports including the
host adapters connected to the ETERNUS DX400/DX8000 series
in Loop-ID.
This setting is enabled only when the Connection Topology is [FC-AL
Connection] and also the [Loop-ID (Auto)] is selected.
Current transfer rate setting can be checked in the "Link Status" column
on the CA details screen (FC) under the [Device Status] menu.