Filter
Top Products
Chapter 1 Operation Screens
> 1.4 Screen Operations
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
28
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
● General Status of the Device
The general status of the device is indicated by a "lamp image".
Device monitor runs every five minutes.
General status of the device is determined by the combined status of each sub-component
(controller enclosure, drive enclosures, cables, etc.) of the device.
Lamp image Description
(Green)
Each component is in normal status.
(Orange)
Component is under maintenance.
(Yellow)
Preventive maintenance is required for some components.
(Red)
This lamp is displayed in the following conditions:
• Component failure is detected.
Check the device status.
• FC-Loop Down is detected.
Check the device status.
(Red)
This lamp is displayed in the following conditions:
• Abnormal status is detected at power-on.
• Abnormal status is detected at power-off.
The device has not started up normally.
• Failed to restore the operating environment at power-on.
• The device is abnormal.
(Red)
Other unknown