Filter
Top Products
Chapter 5 Configuration Menu
> 5.2 RAID Management
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
211
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
This section describes the procedures to initialize the Snap Data Volume.
Procedure
1 Click [Initialize Snap Data Volume] under the RAID Management in the
[Configuration] menu.
→ The [Initialize Snap Data Volume (Initial)] screen appears.
• When Resource Domains are registered in the ETERNUS DX400/
DX8000 series, Snap Data Volumes that can be initialized differ
depending on the current user account.
- When logged on using a Total Administrator account, all the Snap
Data Volumes that are assigned to Resource Domains can be
initialized.
- When logged on using a Resource Domain Administrator account,
only the Snap Data Volumes that are assigned to the relevant
Resource Domain, and only the Snap Dat a V o l u m e s t h a t a r e
assigned to the Shared Resource, can be initialized.
When initializing a Snap Data Volume (SDV), the space allocated to the
SDV from the Snap Data Pool Volume (SDPV) is canceled.
• In the following cases, the Snap Data Volume cannot be
initialized.
When a message to that effect appears, return to the [Menu]
screen by clicking the [OK] button.
- When there is no volume to be initialized
- When the LDE is operating in the RAID Group to which the
initialization target volume belongs
• In the following cases, volumes cannot be selected (The radio
button is not displayed).
- When the status of the volume to be initialized is not Available
- When the SnapOPC/SnapOPC+ session is set
• When the [Initialize Snap Data Volume] is operating in the
ETERNUS DX400/DX8000 series, the volume progress screen
during the initialization is displayed.
Only one Snap Data Volume can be initialized at a time.