Filter
Top Products
Appendix A Screen Details
> A.18 Set CA Parameters
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
753
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
● Setting item
• TCP/IP Setting
- IP Address
Specify IP Address of the iSCSI-RA Port (required).
Numeric characters from 1 to 3 (the first part: 1 to 255, others: 0 to 255) are entered in all
text boxes.
As a default, "192.168.1.xxx" is displayed.
(xxx: The value decided from the iSCSI-RA Port module ID and the port number)
- Subnet Mask
Specify Subnet Mask of the iSCSI-RA Port (required).
Numeric characters from 1 to 3 (0 to 255) are entered in all textboxes.
The default setting is "255.255.255.0".
- Gateway
Specify the Gateway of the iSCSI-RA Port.
Numeric characters from 1 to 3 (0 to 255) are entered in all textboxes.
The initial status is blank.
- iSNS Server
Set ON (Enabled) or OFF (Disabled) for the iSNS server of the iSCSI-RA Port.
The default setting is "OFF (Disabled)".
iSNS (Internet Storage Name Service) is an equivalent to the DNS (Domain Name
System) for the Internet. The iSNS server is used to convert the iSCSI names into IP
addresses.
- iSNS Server IP address
Set the iSNS Server IP Address of the iSCSI-RA Port in numerals 0 – 255.
The initial status is blank.
• iSCSI Setting
- Alias name
Specify the Alias Name of the iSCSI-RA Port (can be omitted).
Alphanumeric characters from 1 -31 characters can be used.
Alias name is a nickname of the iSCSI Name that identifies the iSCSI-RA Port. Since the
iSCSI name is a very long identifier (up to 223 characters), the Alias name is used in
substitution for the iSCSI name.
• Transfer Rate
- Transfer Rate
Set transfer rate of the iSCSI-RA Port.
• Auto-negotiation
• 1Gbit/s Full duplex/Half duplex auto-setting (Default)
• 1Gbit/s Full duplex
• 100Mbit/s Full duplex/Half duplex auto-setting
• 100Mbit/s Full duplex
This is enabled only when [ON] is selected for the iSNS Server setting.