Filter
Top Products
Chapter 6 Settings Menu
> 6.7 Setting Encryption
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
587
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
6.7 Setting Encryption
The following settings can be performed from this menu.
• Set Encryption Mode
6.7.1 Set Encryption Mode
This function is used to enable or disable the encryption mechanism and change the Encryption
Mode.
The procedure to set the encryption mode is described below.
• Set Encryption Mode
• Change Encryption Mode
The procedures are described below.
6.7.1.1 Set Encryption Mode
The procedure to enable the Encryption Mode is described below.
(Change "Encryption Mode invalidity" to "Fujitsu Original Encryption" or "AES")
Procedure
1 Click [Set Encryption Mode] under the Setting Encryption in the [Settings] menu.
→ The [Set Encryption Mode (Initial)] screen appears.
• The Encryption Mode must be set to either Fujitsu Original Encryption or
AES for the encryption mechanism to be used. The other encryption
menus are not available until the Encryption Mode is set.
• The encryption mechanism is turned off by setting the Encryption Mode
to "Encryption Mode invalidity" and rebooting the ETERNUS DX400/
DX8000 series.
Delete all encrypted and encrypting volumes before changing the
Encryption Mode.