Fujitsu DX400 Computer Drive User Manual


 
Appendix A Screen Details
> A.33 Set IP Address for USER Port
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
797
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
Service Settings
- Service Settings
Specify the following service information for the device.
Enable the service information in the [Service Settings] for the ETERNUS DX400/DX8000
series to receive and execute the request (*1).
HTTP Port No.
Enter the HTTP port number in numerals 1 65535 (However, "23", "443", "1999", and
"1372" have already been used for the ETERNUS DX400/DX8000 series, and cannot
be specified for this field).
The default value is 80.
HTTP
Select HTTP port "Enable" or "Disable" with the radio button.
The default setting is "Enable".
HTTPS
Select HTTPS port "Enable" or "Disable" with the radio button.
The default setting is "Enable".
ping
Select ping "Enable" or "Disable" with the radio button.
The default setting is "Enable".
Maintenance Port
Select Maintenance Port (*2) "Enable" or "Disable" with the radio button.
The default setting is "Enable".
Maintenance Secure Port
Select Maintenance Secure Port (*3) "Enable" or "Disable" with the radio button.
The default setting is "Disable".
*1: When a user connects ETERNUSmgr or a PC to the ETERNUS DX400/DX8000 series for checking
the status of the device and performing maintenance, [Enable] the HTTP port or the HTTPS port
according to the specification method of the IP Address (http or https). When the ETERNUS DX400/
DX8000 series receives ping, [Enable] the ping port. When a user connects Storage Foundation
Software ETERNUS SF (such as ETERNUS SF Storage Cruiser) to the ETERNUS DX400/DX8000
series for checking the status of the device and performing maintenance, [Enable] the Maintenance
Port or Maintenance Secure Port.
When using the [Set Remote Support] function or exporting an operation log (Syslog function) to send
error information or operation events to the REMCS Center or the Syslog server, or when sending
ping from the device, the port for Service Settings is not used.
*2: The Maintenance Port is used by Storage Foundation Software ETERNUS SF, such as ETERNUS SF
Storage Cruiser, to interface with ETERNUS DX400/DX8000 series. If Storage Foundation Software
ETERNUS SF is not used, select [Disable] for the "Maintenance Port".
*3: The Maintenance Secure Port is used by Storage Foundation Software ETERNUS SF, such as
ETERNUS SF Storage Cruiser, to interface with ETERNUS DX400/DX8000 series. This port sends
and receives the encrypted communication data. If Storage Foundation Software ETERNUS SF is not
used, select [Disable] for the "Maintenance Secure Port".